Item Button or Fader Function

• 1 Scanner select buttons Fixture selection
• 2 Scanner indicator LEDS Indicates the fixtures currently selected
• 3 Scene select buttons Universal bump buttons representing scene location for storage and selection
• 4 Channel faders For adjusting OMX values, Ch 1~8 can be adjusted immediately after pressing the respective scanner select button, Ch 9~16 after pressing the Page select button
• 5 Page A Indicator LED Represents Ch 1~8 range selected, Tip! Tap A, B then B again to control both pages simultaneously.
• 6 Page B Indicator LED Represents Ch 9~16 range selected
• 7 Page select button In manual mode, press to toggle between pages of control or to select both pages simultaneously. Both LEDS on will allow control of both lower and upper range channel.
• 8 Program button Used to enter programming mode
• 9 Music/Bank Copy button Used to activate Music mode and as the copy command during programming
• 10 LCD display window Status window displays pertinent operational data
• 11 Mode Indicator LEDS Provides operating mode status, (manual, music or auto)
• 12 Bank Up button Function button to traverse Scene/Steps in banks or chases Incremental OMX values while FINE button is active.
• 13 Bank Down button Function button to traverse Scene/Steps in banks or chases Decremental OMX values while FINE button is active.
• 14 Tap Display button This is a Tap-Sync during playback and during programming changes the DMX value displayed in the LCD panel to percentages
• 15 Blackout button Sets the shutter or dimmer value of all fixtures to „O" causing all light output to cease
• 16 Midi/Ree button Activates MIDI external control and also used to confirm the record/save process
• 17 Assign LED Indicated the controller is in Channel assign mode during the initial setup of the controller
• 18 Auto/Del button I Used to activate Auto mode and as the delete function key during programming
• 19 Chaser buttons Chase memor y 1 ~ 6
• 20 Speed fader This will adjust the hold time of a scene or a step within a chase
• 21 Fade-Time fader Also considered a cross-fade, sets the interval time between two scenes in a chase
• 22 Fine button Activates 16 bit control of the wheel, movement will be in extremely small increments. Note: While FINE is active Bank UP/DOWN buttons will increase and decrease OMX values by one for either the wheel or the slider in focus or currently moved.
• 23 Reverse LED
• 24 PAN/TILT Wheel (Joystich) Generally used to control the pan and tilt movement of a fixture
• 25 Mode button
• 26 Override button
• 27 Fog machine button To activate the fog machine
• 28 Fog machine ready indicator
• 29 Fog machine heating indicator
• 30 Audio input jack Direct audio feed for use in sound-active mode
• 31 MIDI input port For external triggering of Banks and Chases using a MIDI device
• 32 DMX polarity switch May be used to correct signal polarity
• 33 DMX output connector DMX control signal
• 34 DMX input connector Used to transfer programmed data between 2 controllers
• 35 Fog machine socket
• 36 DC Input jack Main power feed
• 37 USB Lamp socket
• 38 ON/OFF power switch Turns the controller on and off